Jack and Jack Handle
Posted: Fri Nov 18, 2016 8:53 am
1935 3.5L Park Ward
In the technical manual I see that the car should have a Dunlop 29 Jack.
I had a screw jack under the bonnet but as it was not secure in its cage I have taken it out. Does anyone have a correct jack they would part with?
I am also interested in which bits are clipped where under the bonnet, the starting handle and shaft are fairly obvious but then there are other brackets across the bulkhead above the regulator. Is there an earlier thread relating to this ?
In the technical manual I see that the car should have a Dunlop 29 Jack.
I had a screw jack under the bonnet but as it was not secure in its cage I have taken it out. Does anyone have a correct jack they would part with?
I am also interested in which bits are clipped where under the bonnet, the starting handle and shaft are fairly obvious but then there are other brackets across the bulkhead above the regulator. Is there an earlier thread relating to this ?
