removal 49 steering wheel.

Public visibility
Post Reply
Fred Franken
Posts: 6
Joined: Mon Nov 30, 2020 5:04 pm
Location: Germany

removal 49 steering wheel.

Post by Fred Franken »

How do I remove a 1949 MK6 steering wheel. The manual has a plate with 3 screws, under the chromed screw out button. I don't have that. I have a small hole at the rear of the steering wheel, too small for a wrench, and i can't see a screwdriver slot.
regards fred
Christopher Carnley
Posts: 2753
Joined: Fri Nov 16, 2007 12:00 am
Location: Yorkshire, United Kingdom

Post by Christopher Carnley »

Hi Fred,

First of all you have to remove all the engine levers from below the steering box and the large tabbed nut.

A pain, or then you could forget it?

See MK VI workshop manual S,Q BQ1.
Christopher Carnley
Posts: 2753
Joined: Fri Nov 16, 2007 12:00 am
Location: Yorkshire, United Kingdom

Post by Christopher Carnley »

Hi Fred,

First of all you have to remove all the engine levers from below the steering box and the large tabbed nut.

A pain, or then you could forget it?

See MK VI workshop manual S,Q BQ1.
Christopher Carnley
Posts: 2753
Joined: Fri Nov 16, 2007 12:00 am
Location: Yorkshire, United Kingdom

Post by Christopher Carnley »

Hi Fred,

First of all you have to remove all the engine levers from below the steering box and the large tabbed nut.

A pain, or then you could forget it?

See MK VI workshop manual S,Q BQ1.
Christopher Carnley
Posts: 2753
Joined: Fri Nov 16, 2007 12:00 am
Location: Yorkshire, United Kingdom

Post by Christopher Carnley »

There is something wrong with the machine.
Martin Webster
Posts: 192
Joined: Tue Feb 18, 2003 12:00 am
Location: Hampshire, United Kingdom

Post by Martin Webster »

Chris is quite correct Fred,
It’s a real palaver to remove the steering wheel. If you really need to and you don’t have a workshop manual, go to the Rolls-Royce Owners Club of Australia post war technical library where you will find all the relevant information.
Martin
Christopher Carnley
Posts: 2753
Joined: Fri Nov 16, 2007 12:00 am
Location: Yorkshire, United Kingdom

Post by Christopher Carnley »

Yes Martin, and it is Free of Charge.

From about 15 years ago, this is what you see when the tubes are tapped upwards.

The small hole is for inserting a thinned down 2 BA box spanner for the set screws, but it is very fiddly.
Then the top will lift off, watch out for the horn wire.




Image :)
Post Reply