My Mk6 special has been converted to a single point system using a 6 lobe cam,
I have recently bought a multimeter that can measure dwell angle, what would be an acceptable dwell angle range?
I have read that a 6 cylinder engine should have a dwell angle between 35 - 37 degrees - Would this be correct? I have measure the current dwell angle and I am getting 58 degrees at 550 rpm, decreasing to 52 degrees at 1500 rpm .
This would indicate that I need to reset the points,
Any info on this subject would be well received
Mk 6 Dwell angle
-
Mark Taxis
- Posts: 226
- Joined: Mon Apr 02, 2007 2:57 pm
- Location: Queensland Australia
Mk 6 Dwell angle
Mark Taxis
Sunshine Coast
Queensland 4560
Sunshine Coast
Queensland 4560
- Stephen Blakey
- Posts: 1348
- Joined: Thu Feb 02, 1995 12:00 am
- Location: Derbyshire, United Kingdom
I wonder if you've got part or all of the Delco D200 series distributor which is interchangeable with the earlier Delco unit on the MKVI?
When used on the Triumph GT6, this had a dwell of 41 degrees +/- 1 degree.
Strangely, the same car fitted with a Lucas distributor had a dwell angle of 35 degrees +/- 3. Either way it looks like you're getting too much.
Back in the day, dwell angle was a near obsession with folks running V8's with contact breakers. It's a long time since I've heard of anyone going there. Good luck.
When used on the Triumph GT6, this had a dwell of 41 degrees +/- 1 degree.
Strangely, the same car fitted with a Lucas distributor had a dwell angle of 35 degrees +/- 3. Either way it looks like you're getting too much.
Back in the day, dwell angle was a near obsession with folks running V8's with contact breakers. It's a long time since I've heard of anyone going there. Good luck.
-
Christopher Carnley
- Posts: 2753
- Joined: Fri Nov 16, 2007 12:00 am
- Location: Yorkshire, United Kingdom
-
Mark Taxis
- Posts: 226
- Joined: Mon Apr 02, 2007 2:57 pm
- Location: Queensland Australia
Yes the coil was running very hot and likewise I am suprised it still works
I could not get the points set properly so I invested in a $45 Auto multimeter, now I can read the dwell angle and the RPM.
This proved that the points gap were wrong and also that the rev counter in the car is wildly inaccurate.
I have set the dwell angle to 36 which I think is nearer the right setting.Also by reducing the dwell angle I now have a steady reading accross all revs.
this may be the root cause or at least a part of the problem I experienced a few months ago.
Regards
Mark
I could not get the points set properly so I invested in a $45 Auto multimeter, now I can read the dwell angle and the RPM.
This proved that the points gap were wrong and also that the rev counter in the car is wildly inaccurate.
I have set the dwell angle to 36 which I think is nearer the right setting.Also by reducing the dwell angle I now have a steady reading accross all revs.
this may be the root cause or at least a part of the problem I experienced a few months ago.
Regards
Mark
Mark Taxis
Sunshine Coast
Queensland 4560
Sunshine Coast
Queensland 4560

