stuck clutch

Forum for Crewe Cars through S-Type & Derivatives
(Public visibility)
Post Reply
Richardson Masten
Posts: 49
Joined: Thu Jan 01, 1970 12:00 am
Location: California, USA

stuck clutch

Post by Richardson Masten »

Failed to lodge the clutch pedal down after reinstalling the engine in my 4 1/4. The clutch is stuck on. Using the engine to free it did not work. Squirted acetone on as much as we could see and it's been sitting for two days. Will try the engine and brakes to free, but what about a putty knife at the edge of the clutch between it and the flywheel, working all the way around it?
User avatar
John Murch
Posts: 1586
Joined: Sat Jun 05, 1976 11:00 pm
Location: London, United Kingdom

Post by John Murch »

My experience (although in the distant past) has been that heat usually does the job. Depress the clutch with a wedge or suitable pole, and just let the engine idle for a while, once the heat from the engine has worked its way back, the differential expansion etc., should fix it.
John
Richardson Masten
Posts: 49
Joined: Thu Jan 01, 1970 12:00 am
Location: California, USA

stuck clutch

Post by Richardson Masten »

Thanks John. We've tried that twice with no success yet. We'll be trying again in the morning and I'll advise.
Christopher Carnley
Posts: 2753
Joined: Fri Nov 16, 2007 12:00 am
Location: Yorkshire, United Kingdom

Post by Christopher Carnley »

Could the Borg & Beck clutch plate be stuck on the rusted coarse splines, the coil spring load is rather high?

The BDCL Green Book recommends the use of Diethyl Ether based "Easy Start", liberally sprayed into the clutch housing to penetrate the linings.
Richardson Masten
Posts: 49
Joined: Thu Jan 01, 1970 12:00 am
Location: California, USA

stuck clutch

Post by Richardson Masten »

While I can see that I should have posted this to the Derby site, I thank you for replying. WD40 with an extended pipe squirted into the Borg & Beck at open spots and waiting three days did the trick. Thanks again!
User avatar
John Murch
Posts: 1586
Joined: Sat Jun 05, 1976 11:00 pm
Location: London, United Kingdom

Post by John Murch »

Well done Ric, what a relief😀
Richardson Masten
Posts: 49
Joined: Thu Jan 01, 1970 12:00 am
Location: California, USA

Post by Richardson Masten »

That is for certain! Thanks
Richardson Masten
Posts: 49
Joined: Thu Jan 01, 1970 12:00 am
Location: California, USA

Re: stuck clutch

Post by Richardson Masten »

Ric Masten wrote:Failed to lodge the clutch pedal down after reinstalling the engine in my 4 1/4. The clutch is stuck on. Using the engine to free it did not work. Squirted acetone on as much as we could see and it's been sitting for two days. Will try the engine and brakes to free, but what about a putty knife at the edge of the clutch between it and the flywheel, working all the way around it?
--- Sprayed WD40 with liberality and let it sit. Rocked the chassis whilst in gear and ran the engine against the brakes. The clutch finally became free and operates correctly. Thanks.
Post Reply