I'm slightly embarrassed to be asking this..... how does the wheel trim come off? I'm assuming the octagonal Bentley engaved centre caps unscrew releasing the outer trim thereby revealing the wheel nuts.
Would it be safe to assume that if I am correct that the centre hubs are handed?
If the centre caps are threaded - I'll need to make a tool out of ally plate, I guess - unless anyone has a better idea......?
R Type wheel trim
-
Al Coutts
- Posts: 108
- Joined: Sun Sep 25, 2016 11:00 pm
- Location: Norfolk, United Kingdom
- John Murch
- Posts: 1586
- Joined: Sat Jun 05, 1976 11:00 pm
- Location: London, United Kingdom
-
Christopher Carnley
- Posts: 2753
- Joined: Fri Nov 16, 2007 12:00 am
- Location: Yorkshire, United Kingdom
-
Christopher Carnley
- Posts: 2753
- Joined: Fri Nov 16, 2007 12:00 am
- Location: Yorkshire, United Kingdom
-
Al Coutts
- Posts: 108
- Joined: Sun Sep 25, 2016 11:00 pm
- Location: Norfolk, United Kingdom
-
Christopher Carnley
- Posts: 2753
- Joined: Fri Nov 16, 2007 12:00 am
- Location: Yorkshire, United Kingdom
-
Christopher Carnley
- Posts: 2753
- Joined: Fri Nov 16, 2007 12:00 am
- Location: Yorkshire, United Kingdom
Al,
2 nice cylinders. I invariably have them re-sleeved at Past Parts in Ipswich, as at 70 years old the bores are always a bit bell mouthed and scored/pitted. These look OK but you can never be sure of long term serviceability and P.P are very reasonable. They fit the stainless liners with Permabond to avoid hydraulic leaks as the centre pressure feed is drilled through it.


I was to have them sleeved for service but after the fiasco with the last heap of seized abandoned scrap, I now refuse to have anything to do with complete cars.I have too much axle and gearbox work for one man, anyway.
2 nice cylinders. I invariably have them re-sleeved at Past Parts in Ipswich, as at 70 years old the bores are always a bit bell mouthed and scored/pitted. These look OK but you can never be sure of long term serviceability and P.P are very reasonable. They fit the stainless liners with Permabond to avoid hydraulic leaks as the centre pressure feed is drilled through it.


I was to have them sleeved for service but after the fiasco with the last heap of seized abandoned scrap, I now refuse to have anything to do with complete cars.I have too much axle and gearbox work for one man, anyway.


