Christopher Davis
Joined: 13 Dec 2018
Posts: 4
Location: Pennsylvania, USA
|
 Posted: Sat Feb 12, 2022 3:31 pm Post subject: Mk Brake Intermediate Shaft Levers |
 |
|
Can anyone provide insights on the correct/original diameter of the bearing pin holes of the Intermediate Shaft Levers?  |
|
Christopher Carnley
Joined: 16 Nov 2007
Posts: 2746
Location: Yorkshire, United Kingdom
|
| Posted: Sat Feb 12, 2022 5:25 pm Post subject: |
|
|
5/16" or .312". If the jaws of the clevis are worn then the pin should be replaced by an oversize.
Some were being made by Ristes in Nottingham.
The original pins are high grade case hardened steel and should have been oiled at service, but rarely were. |
|
