Has anyone had a go at renovating their "A" type gearbox?
Would love to hear
Is Brineton still in business?
NDR and DH DAY seem to have the very same parts list as if its sourced from another supplier
A type gearbox
-
Roderick Hanson
- Posts: 7
- Joined: Thu Feb 07, 2013 12:00 am
- Location: Victoria, Australia
- John Murch
- Posts: 1586
- Joined: Sat Jun 05, 1976 11:00 pm
- Location: London, United Kingdom
For ages Brineton's advert had an error in its web page address, I imagine its been corrected now, http://www.brineton-eng.co.uk/index.html
-
Andrew_T
- Posts: 2
- Joined: Wed Jul 17, 2019 8:18 pm
- Location: Northamptonshire, United Kingdom
- AnthonyEssington8982
- Posts: 114
- Joined: Thu Jul 09, 2009 11:00 pm
- Location: West Midlands, United Kingdom
- John Murch
- Posts: 1586
- Joined: Sat Jun 05, 1976 11:00 pm
- Location: London, United Kingdom
-
Roderick Hanson
- Posts: 7
- Joined: Thu Feb 07, 2013 12:00 am
- Location: Victoria, Australia
A type gearbox
Thank you all for responding
Brineton never made contact
The old gear set were pretty worn but the bearings were not too bad. Replaced bearings as well.
New gear set looking good as we begin to reassemble.
The main issue is end float on the main shaft, said to be .004" and we have settled for about .008"
Eccentricity in the lay shaft is next.
All in all it has not been too challenging.
Along with replacing the cone clutch and clutch brake we are looking forward to some smoother motoring!
Rod Hanson #197
Brineton never made contact
The old gear set were pretty worn but the bearings were not too bad. Replaced bearings as well.
New gear set looking good as we begin to reassemble.
The main issue is end float on the main shaft, said to be .004" and we have settled for about .008"
Eccentricity in the lay shaft is next.
All in all it has not been too challenging.
Along with replacing the cone clutch and clutch brake we are looking forward to some smoother motoring!
Rod Hanson #197
- Robin Hine
- Posts: 1
- Joined: Fri Jun 05, 1981 11:00 pm
- Location: BC, Canada
I see this is a few years ago now. My A box is on the table, I'll try for .004 - .008" main shaft end float.
My question - how and what did you settle for on the eccentricity lay shaft issue?? My bearing caps were horribly worn, I have new caps and now need to set them up.
Any thoughts would be appreciated.
My question - how and what did you settle for on the eccentricity lay shaft issue?? My bearing caps were horribly worn, I have new caps and now need to set them up.
Any thoughts would be appreciated.

