A type gearbox

Forum specifically for WO Bentley car issues.
(Public visibility)
Post Reply
Roderick Hanson
Posts: 7
Joined: Thu Feb 07, 2013 12:00 am
Location: Victoria, Australia

A type gearbox

Post by Roderick Hanson »

Has anyone had a go at renovating their "A" type gearbox?
Would love to hear
Is Brineton still in business?
NDR and DH DAY seem to have the very same parts list as if its sourced from another supplier
User avatar
John Murch
Posts: 1586
Joined: Sat Jun 05, 1976 11:00 pm
Location: London, United Kingdom

Post by John Murch »

For ages Brineton's advert had an error in its web page address, I imagine its been corrected now, http://www.brineton-eng.co.uk/index.html
Andrew_T
Posts: 2
Joined: Wed Jul 17, 2019 8:18 pm
Location: Northamptonshire, United Kingdom

Post by Andrew_T »

Tula bought all the Brineton stock and trading name last year, theyre Bugatti specialists. I havent asked what their plans are for the Bentley spares.

I have a new set of internals to go in my A box, not sure when I will have time, but it looks like an easy job.
User avatar
AnthonyEssington8982
Posts: 114
Joined: Thu Jul 09, 2009 11:00 pm
Location: West Midlands, United Kingdom

Post by AnthonyEssington8982 »

I live local to Brineton, someone I know says they scrapped all the Bentley stuff in the scrap yard next door.
User avatar
John Murch
Posts: 1586
Joined: Sat Jun 05, 1976 11:00 pm
Location: London, United Kingdom

Post by John Murch »

Tula did take on much of the Bentley parts from Brineton.
Roderick Hanson
Posts: 7
Joined: Thu Feb 07, 2013 12:00 am
Location: Victoria, Australia

A type gearbox

Post by Roderick Hanson »

Thank you all for responding
Brineton never made contact
The old gear set were pretty worn but the bearings were not too bad. Replaced bearings as well.
New gear set looking good as we begin to reassemble.
The main issue is end float on the main shaft, said to be .004" and we have settled for about .008"
Eccentricity in the lay shaft is next.
All in all it has not been too challenging.
Along with replacing the cone clutch and clutch brake we are looking forward to some smoother motoring!
Rod Hanson #197
User avatar
Robin Hine
Posts: 1
Joined: Fri Jun 05, 1981 11:00 pm
Location: BC, Canada

Post by Robin Hine »

I see this is a few years ago now. My A box is on the table, I'll try for .004 - .008" main shaft end float.
My question - how and what did you settle for on the eccentricity lay shaft issue?? My bearing caps were horribly worn, I have new caps and now need to set them up.
Any thoughts would be appreciated.
Post Reply