Page 1 of 1

stuck clutch

Posted: Sun Mar 05, 2017 10:48 pm
by Richardson Masten
Failed to lodge the clutch pedal down after reinstalling the engine in my 4 1/4. The clutch is stuck on. Using the engine to free it did not work. Squirted acetone on as much as we could see and it's been sitting for two days. Will try the engine and brakes to free, but what about a putty knife at the edge of the clutch between it and the flywheel, working all the way around it?

Posted: Mon Mar 06, 2017 5:49 am
by John Murch
My experience (although in the distant past) has been that heat usually does the job. Depress the clutch with a wedge or suitable pole, and just let the engine idle for a while, once the heat from the engine has worked its way back, the differential expansion etc., should fix it.
John

stuck clutch

Posted: Mon Mar 06, 2017 6:02 am
by Richardson Masten
Thanks John. We've tried that twice with no success yet. We'll be trying again in the morning and I'll advise.

Posted: Mon Mar 06, 2017 9:17 am
by Christopher Carnley
Could the Borg & Beck clutch plate be stuck on the rusted coarse splines, the coil spring load is rather high?

The BDCL Green Book recommends the use of Diethyl Ether based "Easy Start", liberally sprayed into the clutch housing to penetrate the linings.

stuck clutch

Posted: Mon Mar 13, 2017 5:38 am
by Richardson Masten
While I can see that I should have posted this to the Derby site, I thank you for replying. WD40 with an extended pipe squirted into the Borg & Beck at open spots and waiting three days did the trick. Thanks again!

Posted: Mon Mar 13, 2017 5:56 am
by John Murch
Well done Ric, what a relief😀

Posted: Mon Mar 13, 2017 7:49 am
by Richardson Masten
That is for certain! Thanks

Re: stuck clutch

Posted: Sun Jul 30, 2017 6:00 am
by Richardson Masten
Ric Masten wrote:Failed to lodge the clutch pedal down after reinstalling the engine in my 4 1/4. The clutch is stuck on. Using the engine to free it did not work. Squirted acetone on as much as we could see and it's been sitting for two days. Will try the engine and brakes to free, but what about a putty knife at the edge of the clutch between it and the flywheel, working all the way around it?
--- Sprayed WD40 with liberality and let it sit. Rocked the chassis whilst in gear and ran the engine against the brakes. The clutch finally became free and operates correctly. Thanks.