Page 1 of 1

A type gearbox

Posted: Sat Mar 26, 2022 10:53 am
by Roderick Hanson
Has anyone had a go at renovating their "A" type gearbox?
Would love to hear
Is Brineton still in business?
NDR and DH DAY seem to have the very same parts list as if its sourced from another supplier

Posted: Sun Mar 27, 2022 6:13 am
by John Murch
For ages Brineton's advert had an error in its web page address, I imagine its been corrected now, http://www.brineton-eng.co.uk/index.html

Posted: Mon Mar 28, 2022 11:49 am
by Andrew_T
Tula bought all the Brineton stock and trading name last year, theyre Bugatti specialists. I havent asked what their plans are for the Bentley spares.

I have a new set of internals to go in my A box, not sure when I will have time, but it looks like an easy job.

Posted: Mon May 09, 2022 5:50 pm
by AnthonyEssington8982
I live local to Brineton, someone I know says they scrapped all the Bentley stuff in the scrap yard next door.

Posted: Tue May 10, 2022 10:49 am
by John Murch
Tula did take on much of the Bentley parts from Brineton.

A type gearbox

Posted: Sat Jun 04, 2022 7:39 am
by Roderick Hanson
Thank you all for responding
Brineton never made contact
The old gear set were pretty worn but the bearings were not too bad. Replaced bearings as well.
New gear set looking good as we begin to reassemble.
The main issue is end float on the main shaft, said to be .004" and we have settled for about .008"
Eccentricity in the lay shaft is next.
All in all it has not been too challenging.
Along with replacing the cone clutch and clutch brake we are looking forward to some smoother motoring!
Rod Hanson #197

Posted: Wed Mar 18, 2026 4:59 pm
by Robin Hine
I see this is a few years ago now. My A box is on the table, I'll try for .004 - .008" main shaft end float.
My question - how and what did you settle for on the eccentricity lay shaft issue?? My bearing caps were horribly worn, I have new caps and now need to set them up.
Any thoughts would be appreciated.