Christopher Power
Joined: 01 Jan 1970
Posts: 28
Location: Hampshire, United Kingdom
|
 Posted: Sun Oct 08, 2017 4:05 pm Post subject: Adjustment of Sloper Carburettors |
 |
|
| Section 2.3.1 in the Technical Facts seems to say that the seven following paragraphs ONLY refers to the earliest type of which few probably exist. I suspect that some of the rest of the section actually applies to later slopers, but it doesn't seem to say where the latter starts. Can anyone advise please? |
|
Robert Craven
Joined: 09 Apr 2004
Posts: 554
Location: Swansea, United Kingdom
|
| Posted: Mon Oct 09, 2017 10:01 am Post subject: |
|
|
At the end of section 2.3.1 (2) [I've added the first bracket to make the reference clearer] it says "The general information given below is equally applicable to early and late models of this type of carburettor"
This means what it says, though in fact I think you may sometimes need to move the needle slightly in the later types and therefore refer to 2.3.1 (1) & (2) as well as the following sections. |
|
Christopher Power
Joined: 01 Jan 1970
Posts: 28
Location: Hampshire, United Kingdom
|
| Posted: Mon Oct 09, 2017 10:32 am Post subject: Adjustment of Sloper Carburettors |
|
|
| Very many thanks, Robert. I'm afraid I had written off the whole of 2.3.1 on the basis of the opening paragraph. I should have read further! Thanks for such a quick answer. |
|
